Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 24)

The On-Screen Display (OSD)
16 · G&D DVICenter
3. Select the Default location entry and press F8 (repeatedly) to select the desired setting.
4. Press F2 to save your changes.
Changing the display‘s position
When accessing a target module, the information display of the matrix system e.g.
provides you with the name of the accessed target module and the name of the user
module.
By default, the information display is located in the left upper corner at the console
monitor. You can adjust the display’s position according to your wishes.
Your individual setting is assigned to your user account and stored in your Personal
Profile.
How to change the display position:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F10 to call the Personal Profile menu.
3. Select the Set display position entry and press Enter .
4. The menu on the right-hand side opens at the display
position.
5. Use the arrow keys or the mouse to move the menu to
the desired position.
6. Press F2 to save your settings or press Esc to cancel.
Changing the OSD position
By default, the information is located in the centre of the console monitor. You can
adjust the display’s position according to your wishes.
The selected setting is assigned to your user account and stored in your Personal Profile.
All: All target modules are displayed.
Last: The view filter that was used by the last user is applied when the
Select menu is called.
Selection of
a folder:
The view filter of the selected group is applied if the Select menu is
called.
IMPORTANT: If the LAST option has been selected and two users are using one user
account at the same time, the view filter of the previously active person is stored.
NOTE: Press Ctrl+D to reset the display’s position and font size.
ADVICE: Press Ctrl+A to select this view filter directly.
+
Display position
F2: Save