Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 22)

The On-Screen Display (OSD)
14 · G&D DVICenter
Adjusting the on-screen display’s transparency
In the on-screen display’s default settings, the screen content under the OSD is semi-
visible. The screen content shines through the part that is covered by the OSD.
You can either adjust or turn off the OSD’s transparency in the personal profile of a
user.
How to adjust the on-screen display’s transperency:
1. Press the
Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F10 to call the Personal Profile menu.
3. Select the OSD transparency entry and press F8 (repeatedly) to select one of the fol-
lowing options:
4. Press F2 to save the changes.
Adjusting the information display
When switching to a target module, a temporary information display (5 seconds)
opens. The display informs you about the console name, the name of the currently
accessed target module and provides further information.
The information display can also be permanently displayed or deactivated. The selected
setting is assigned to your user account and stored in your Personal Profile.
How to change the settings of the information display:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F10 to call the Personal Profile menu.
3. Select the Display entry and press F8 (repeatedly) to select one of the following
options:
4. Press F2 to save the changes.
high: Screen content almost completely visible
average: Screen content semi-visible (default)
low: Screen content slightly visible
off: Screen content is covered
ADVICE: When active, the temporary information can be recalled by pressing
Ctrl+Caps Lock .
temp: show information display (five seconds)
perm: permanent information display
off: deactivate information display