Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 71)

Target modules
G&D DVICenter · 63
5. Select the Name entry and press Enter .
6. Enter the new name and press Enter .
7. Press F2 to save your settings.
How to rename a target module in the Select menu:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Select the target module to be renamed.
3. Press F5 .
4. Change the name and press Enter .
Deleting a target module from the KVM matrix system
If the matrix system is not able to detect a target module that has already been con-
nected to the system, the device is defined as inactive.
Therefore, the list entry of the target module you want to permanently remove from
the system has to be manually removed.
How to delete a target module that is inactive or disconnected from the system:
1. Press the
Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F11 to call the Configuration menu.
3. Select the Target entry and press Enter .
NOTE: The message »Name exists« is displayed if a target module with the same
name has already been connected to the system.
The settings of such target modules are stored within the matrix system and are
only visible in the Config Panel web application. If necessary, use the web appli-
cation to delete the target module from the system.
Afterwards, this name can be assigned to another target module.
NOTE: Use the menu’s search function, the view filter or the sort criteria (see
page 9 ff.) to limit the selection of list entries.
NOTE: The message »Name exists« is displayed if a target module with the same
name has already been connected to the system.
The settings of such target modules are stored within the matrix system and are
only visible in the Config Panel web application. If necessary, use the web appli-
cation to delete the target module from the system.
Afterwards, this name can be assigned to another target module.
NOTE: Only inactive target modules can be deleted.