Reading out the status of the network interfaces – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 112
System settings and functions
104 · G&D DVICenter
5. Select
Freeze function
and press
F8
to select one of the following options:
6. When the Freeze function is explicitly enabled for this user module, enable one or
both options under
Freeze visualization
:
7. Press
F2
to save your settings.
Reading out the status of the network interfaces
The current status of both network interfaces can always be read out via the on-
screen display.
How to detect the status of the network interfaces:
1. Press
Ctrl+Num
(default) to open the on-screen display.
2. Press
F11
to open the Configuration menu.
3. Select
Network
and press
Enter
.
4. Select
Link Status
and press
Enter
.
5. The
Interface A
(Network A interface) or
Interface B
(Network B interface) paragraph
provides you with the following data:
6. Press
Esc
to leave the menu.
system:
Apply setting to the entire system (see above).
off:
Shows no image when connection is lost.
on:
Shows last image when connection is lost.
frame:
Shows a coloured frame when connection is lost.
OSD:
Shows the note
Frozen
and the time past since the loss of
connection.
frame+OSD:
Shows a coloured frame and the note
Frozen
with the time
past since the loss of connection.
Link detected:
connection to network established (
yes
) or interrupted (
no
).
Auto-negotiation:
The transmission speed and the duplex mode have been con-
figured automatically (
yes
) or manually by the administrator
(
no
).
Speed:
transmission speed
Duplex
duplex mode (
full
or
half
)
NOTE:
Press
Enter
to update the displayed data.