Setting the hold time for the screensaver – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 92
User modules
84 · G&D DVICenter
Setting the hold time for the screensaver
The screensaver deactivates the screen display at the user module after the user has
been inactive for a configurable amount of time.
How to set the hold time of the screensaver:
1. Press the
Ctrl+Num
(default) hotkey to open the on-screen display.
2. Press
F11
to call the Configuration menu.
3. Select the
Console
entry and press
Enter
.
4. Select the user module whose settings are you want to change and press
F5
.
5. Select the
Screensaver (min)
entry and press
Enter
.
6. Enter a number between
1
and
99
minutes to activate the screensaver and press
Enter
.
7. Press
F2
to save your settings.
NOTE:
This setting works independently from the screensaver settings of the target
computer.
ADVICE:
Use the menu’s search function or the sort criteria (see page 9 ff.) to limit
the selection of list entries.
ADVICE:
The value »0« deactivates the screensaver.