Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 111)

System settings and functions
G&D DVICenter · 103
Enable the freeze mode if you want to display the last image received at the user
module before the loss of connection. This image is displayed until the connection is
re-established.
You can set the freeze mode for the entire system, too. The setting for the entire sys-
tem applies to all user modules. In addition, you can set the freeze mode individu-
ally for each user module.
How to configure the freeze mode for the entire system:
1. Press Ctrl+Num (default) to open the on-screen display.
2. Press F11 to open the Configuration menu.
3. Select System and press Enter .
4. Select Freeze function and press F8 to select one of the following options:
5. If the Freeze function is enabled, select one of the options under Freeze visualization :
6. Press F2 to save your settings.
How to configure the freeze mode individually for a user module:
1. Press Ctrl+Num (default) to open the on-screen display.
2. Press F11 to open the Configuration menu.
3. Select Console and press Enter .
4. Select the user module you want to configure and press F5 .
ADVICE: To emphasize the lost connection, the image last received is either high-
lighted by a coloured frame and/or the note Frozen and the time past since the loss
of connection.
off: Shows no image when connection is lost (default).
on: Shows last image when connection is lost.
frame: Shows a coloured frame when connection is lost.
OSD: Shows the note Frozen and the time past since the loss of
connection.
frame+OSD: Shows a coloured frame and the note Frozen with the time
past since the loss of connection.
ADVICE: Use the menu’s search function, the view filter or the sort criteria (see
page 9 ff.) to limit the selection of list entries.