Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 42)

Switching the target modules automatically or manually
34 · G&D DVICenter
Applying the Autoskip function
How to start the Autoskip function:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F9 to call the Operation menu.
3. Press B or select the B - Autoskip entry and press Enter .
How to stop the Autoskip function:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
This causes the Autoskip function to stop.
Configuring the scantime of the Autoskip function
By default, each target module is accessed for five seconds. After that, the target
module is disconnected and the next target module is accessed.
Select a time span between 1 and 99 seconds to define how long the target module is
to be accessed.
How to change the scantime:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F10 to call the Personal Profile menu.
3. Move the cursor to the Scantime entry and enter a span between 1 and 99 seconds.
4. Press F2 to save your settings.
Requirements for using the Autoskip function:
 Creating a scanmode set (see page 36)
 Assigning a scanmode set to a user account (see page 39)
ADVICE: After the on-screen display has been called, you are enabled to activate
the Autoskip function in the Select menu by pressing Ctrl+B .