Showing messages, Opening or closing the osd – Guntermann & Drunck DVICenter DP16 Configuration and Operation User Manual
Page 133
Controlling the matrix switch via XML
G&D DVICenter · 125
Showing messages
Use the command
to send a message to a user module. Users at the
user module can see the message on their OSD.
The following parameters are required to send commands:
Opening or closing the OSD
Use the commands
and
to open or close the OSD (Select
menu) on a user module.
SWITCHING THE USER MODULE TO CHANNEL 1
SWITCHING THE USER MODULE TO THE CHANNEL
CONNECTED TO THE MATRIX SWITCH
connected to the matrix switch
NOTE:
As of version 1.1 of the XML API, you can add an optional timeout (time
in seconds). After the time elapses, the message closes automatically.
Type of message (
INFO
,
WARNING
or
ERROR
)
Text of message to be shown
Time in seconds after which the message is closed automatically
User module, which shows the message
SHOWING A MESSAGE (WITH TIMEOUT)