Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 43)

Switching the target modules automatically or manually
G&D DVICenter · 35
Scanning the target modules manually (Stepscan)
By pressing a key, the Stepscan function successively accesses any target module that
is included in the scanmode set and available to the user.
When accessing the target modules, the workplace name, the name of the currently
accessed target module, and a note regarding the Stepscan function are displayed.
(De)activating the Stepscan function
How to activate the Stepscan function:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F9 to call the Operation menu.
3. Press C or select the C - Stepscan entry and press Enter .
How to deactivate the Stepscan function:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
This causes the Stepscan function to stop.
Switching between the target modules
How to switch between target modules via Stepscan function:
1. Press the
Up stepkey (default) to access the next target module or the
Down stepkey (default) to access the previous target module.
Requirements to use this function:

Creating a scanmode set (see page 36)
 Configuring keys to scan the targets manually (see page 36)
 Assigning a scanmode set to a user account (see page 39)
ADVICE: After the on-screen display has been called, you are enabled to activate
the Stepscan function in the Select menu by pressing Ctrl+C .