Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 86)

User modules
78 · G&D DVICenter
How to delete an inactive or disconnected user module from the system:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F11 to call the Configuration menu.
3. Select the Console entry and press Enter .
4. Select the user module you want to delete and press F4 .
5. Use the arrow keys to select Yes and press Enter to respond to the prompt for
confirmation.
Settings for special hardware
Adjusting the scancode set of a PS/2 keyboard
If a key is pressed on the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scan code sets (sets 2 and 3) contain dif-
ferent scan codes.
The KVM switch interprets all inputs of the PS/2 keyboard with scan code set 2.
If the pipe (“|”) cannot be entered or if the arrow keys of the keyboard do not work
as expected, it is recommended to switch to scan code set 3.
How to select the scancode set of the PS/2 keyboard:
1. Press the Ctrl+Num (default) hotkey to open the on-screen display.
2. Press F11 to call the Configuration menu.
3. Select the Console entry and press Enter .
4. Select the user module whose settings you want to change and press F5 .
5. Select the Scancode entry and press F8 to select the scancode sets 2 or 3 .
6. Press F2 to save your settings.
7. Restart the user module to apply your changes.
ADVICE: Use the menu’s search function or the sort criteria (see page 9 ff.) to limit
the selection of list entries.
ADVICE: Use the menu’s search function or the sort criteria (see page 9 ff.) to limit
the selection of list entries.