Guntermann & Drunck DVICenter DP16 Configuration and Operation - Manual (Page 109)

System settings and functions
G&D DVICenter · 101
How to configure the network port settings:
1. Press Ctrl+Num (default) to open the on-screen display.
2. Press F11 to open the Configuration menu.
3. Select Network and press Enter .
4. Select Settings and press Enter .
5. Enter the following data in the Interface A (interface Network A) or Interface B (inter-
face Network B) section:
6. Press F2 to save your settings.
Configuring global network settings
In complex networks global network settings ensure that the matrix switch is availa-
ble from all sub networks.
How to configure the global network settings:
1. Press Ctrl+Num (default) to open the on-screen display.
2. Press F11 to open the Configuration menu.
3. Select Network and press Enter .
4. Select Settings and press Enter .
Operational
mode:
Press F8 to select the operating mode of the interface
Network A or Network B :
 Off: switches off network interface.
 Static: uses static settings.
 DHCP: obtains the settings from a DHCP server.
IP address: Enter the interface IP address.
This setting is auto obtained in the DHCP operating mode.
Netmask: Enter the network netmask.
This setting is auto obtained in the DHCP operating mode.
Connection type: Press F8 to define if the network port and its communication
partner are to negotiate the connection type automatically
( Auto ) or select one of the listed types.