Comtech EF Data CDM-750 - Manual (Page 216)

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Serial-based Remote Product Management MN-CDM750
7–36
Parameter
Type
Command
(Instruction
& Qualifier)
Number of
Arguments
Description of Arguments
Response to
Command
Query
(Instruction &
Qualifier)
Response to Query
CnC Fractional
Time
Remaining
N/A 11 byte Query only
Returns the fractional CnC time remaining in the current 365 day period in the form DD:HH:MM:SS, where:
DD=The number of days
HH=The number of hours
MM=The number of minutes
SS= The number of seconds
NOTE: This timer is only active when fractional CnC is purchased and CnC is enabled and running. When the timer hits
zero, CnC will be disabled until the current 365 day period expires. When the current 365 day period expiers, the
fractional timer will automatically reset to 90 days. N/A FCC? FCC=DD:HH:MM:SS
(see Description of
Arguments)
Time remaining
in 365 day
period N/A 12 bytes Query only
Returns the time remaining in the current 365 day period, in the form DD:HH:MM:SS, where:
DD=The number of days
HH=The number of hours
MM=The number of minutes
SS=The number seconds
NOTE: When the timer hits zero, it will automatically reset to and begin counting down again. N/A FCF? FCF=DD:HH:MM:SS
(see Description of
Arguments)
Demo Time
remaining
N/A 11 byte Query only
Returns the Demo time remaining in the form DD:HH:MM:SS, where:
DD=The number of days
HH=The number of hours
MM=The number of minutes
SS=The number seconds
IMPORTANT NOTE! The Demo Mode timer cannot be reset. This timer is active only when Demo Mode is enabled.
When the timer hits zero, Demo Mode is permanently disabled. N/A DMT? DMT=DD:HH:MM:SS
(see Description of
Arguments)