Comtech EF Data CDM-750 - Manual (Page 117)

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Front Panel Operation MN-CDM750
5–39
(CONFIG) IP Config: SNMP ÆTraps
Traps: Community Version
IP-Addr#1 IP-Addr#2
()
Use the W X arrow keys to select Community, Version, IP‐Addr#1, or IP‐Addr#2, and then press
ENTER.
(CONFIG) IP Config: SNMP
Æ Traps Æ Community
SNMP Traps Community:
Comtech (20 chars) (
v)
To edit the SNMP Traps Community string: First, use the W X arrow keys to select the alpha‐
numeric character to edit, and then use the ST arrow keys to edit that character.
Note that only the first 20 characters on the bottom line are available. All printable ASCII
characters are available with the exception of the backslash ‘/’ (ASCII code 92) and tilde ‘~’
(ASCII code 126).
Press ENTER once you compose this string. All trailing spaces are removed from the Traps
Community string upon entry.
(CONFIG) IP Config: SNMP
Æ Traps Æ Version
SNMP Traps Version:
SNMP-ver1 (ver1,ver2)
()
Use the
◄ ► arrow keys to select SNMP‐ver1 or SNMP‐ver2, and then press ENTER.
(CONFIG) IP Config: SNMP Æ Traps Æ IP-Addr#X
Trap IP addr #X:
000.000.000.000
( v)
To edit the SNMP Trap Destination IP Address (where X designates the submenu as Trap IP
Address #1 or Trap IP Address #2): First, use the W X arrow keys to select a digit to edit, and
then use the ST arrow keys to edit that digit. Press ENTER when done.
If both Trap IP Addresses are 000.000.000.000, it means Trap is disabled.