Comtech EF Data CDM-750 - Manual (Page 145)

6–1
Chapter 6. ETHERNET-BASED
REMOTE PRODUCT
MANAGEMENT
6.1 Introduction
Ethernet‐based Remote Product Management is available through the CDM‐750 rear panel ‘J4 |
MGMT’ RJ‐45 10/100 BaseT Fast Ethernet M&C port.
1. TO PROCEED WITH ETHERNET‐BASED REMOTE PRODUCT MANAGEMENT (SNMP
OR WEB SERVER), ASSUMPTIONS ARE MADE THAT:
• The CDM‐750 is operating with the latest version firmware files.
• The CDM‐750 is connected to a user‐supplied, Windows‐based PC, and:
o The PC serial port is connected to the CDM‐750 rear panel ‘J3 |
REMOTE’ port with a user‐supplied serial cable.
o The PC Ethernet port is connected to the CDM‐750 rear panel ‘J4 |
MGMT’ 10/100 BaseT Ethernet port with a user‐supplied hub, switch, or
direct Ethernet cable connection.
o The user PC is running a terminal emulation program (for operation of
the CDM‐750 Serial Interface) and a compatible Web browser (for
operation of the CDM‐750 Web Server Interface).
• The CDM‐750 Management IP Address has been noted using the CDM‐750
Serial Interface.
2. USE OF THE ETHERNET‐BASED SNMP INTERFACE IS RECOMMENDED ONLY FOR
ADVANCED USERS. ALL OTHER USERS ARE STRONGLY ENCOURAGED TO USE THE
CDM‐750 WEB SERVER INTERFACE FOR MONITOR AND CONTROL (M&C) OF THE
CDM‐750.