Comtech EF Data CDM-750 - Manual (Page 115)

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Front Panel Operation MN-CDM750
5–37
5.2.2.9 CONFIG: IP
IP Config:
Addresses SNMP
()
Select Addresses or SNMP using the W X arrow keys, and then press ENTER.
5.2.2.9.1 (CONFIG) IP Config: Addresses
IP Addresses: MAC Gateway
Addr/Range
()
Select MAC, Gateway, or Addr/Range using the W X arrow keys, and then press ENTER.
(CONFIG) IP Config: Addresses Æ MAC
Ethernet MAC Address:
00-06-B0-00-01-06
(read-only)
This read‐only screen displays the unit MAC address. Press ENTER or CLEAR to return to the previous
menu.
(CONFIG) IP Config: Addresses
Æ Gateway
Ethernet IP Gateway:
192.168.001.002
( v)
The Gateway Address is the default next hop address used by the M&C to send traffic to when
the M&C is sending a datagram to an IP address outside of its subnet mask or Address/Range.
This address must be one that is within the M&Cs subnet address/range.
To configure the unit’s IP Gateway Address for the J4 | MGMT (Ethernet M&C) port: First, use
the W X arrow keys to select a digit to edit, and then use the ST arrow keys to change that
digit. Press ENTER when done.
(CONFIG) IP Config: Addresses Æ Address/Range
Ethernet IP Address/Range:
192.168.001.002/24
( v)
To configure the unit’s IP Address for the J4 | MGMT (Ethernet M&C) port: First, use the W X
arrow keys to select a digit to edit, and then use the ST arrow keys to change that digit. Press
ENTER when done.