Comtech EF Data CDM-750 - Manual (Page 158)

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Ethernet-based Remote Product Management MN-CDM750
6–14
6.5.4.2.2 Admin | SNMP
• Sect. 5.2.2.9.2 (CONFIG) IP Config: SNMP in Chapter 5. FRONT PANEL
OPERATION
• Sect. 6.3 SNMP INTERFACE
The Administrator must use this page to manage the CDM‐750 SNMP (Simple Network
Management Protocol) settings.
Figure 6-4. Admin | SNMP page
SNMP
• Use the Simple Network Management drop‐down list to select Enabled or Disabled.
• Enter a Read Community string. This string can be any combination of characters and a
length of 0 to 20 characters. The factory default SNMP Read Community string is public.
• Enter a Write Community string. This string can be any combination of characters and a
length of 0 to 20 characters. The factory default SNMP Write Community string is private.
• Enter an SNMP Contact, Name, and Location. Each string can be any combination of
characters and a length of 0 to 20 characters.
• Use the Enable Authentication Trap drop‐down list to select Enabled or Disabled.
• Enter the Trap IP 1 and Trap IP 2 addresses, in the form XXX.XXX.XXX.XXX, for the computer
that is to receive the traps generated by the CDM‐750.
• Use the Trap Version drop‐down list to select SNMPv1 or SNMPv2.
• Enter a Trap Community String. This string can be any combination of characters and a
length of 0 to 20 characters. The factory default SNMP Write Community string is comtech.
Click [Submit Admin] to save these settings.