Comtech EF Data CDM-750 - Manual (Page 187)

CDM-750 Advanced High-Speed Trunking Modem Revision 2
Serial-based Remote Product Management MN-CDM750
7–7
7.5 Remote Commands and Queries
7.5.1 Table Indexes
Notes:
1. Index Columns – Where Column ‘C’ = Command, and Column ‘Q’ = Query, columns marked ‘X’ designate the instruction code as
Command only, Query only, or Command or Query.
2. In the tables that follow, the following codes are used in the ‘Response to Command’ column (per Sect. 7.4.2.5):
= Message ok # Message ok, but unit is not in Remote mode.
? Received ok, but invalid arguments were found. ~ Time out of a pass‐through messageto a local ODU
^ Message ok, but unit is in Ethernet mode.
Sect. 7.5.2 Tx Parameters
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
TAR X X 7-11 TFQ X X 7-10 TMC X X 7-10 TSI X X 7-11
TDR X X 7-11 TGS X X 7-11 TPI X X 7-12 TSR X X 7-11
TFM X X 7-10 TLP X 7-12 TPL X X 7-12 TXO X X 7-12
Sect. 7.5.3 Rx Parameters
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
EBA X X 7-14 RAR X 7-14 RFQ X X 7-13 RPI X 7-14
EDR X 7-15 RDR X 7-14 RGS X X 7-14 RSI X 7-14
MDR X 7-14 RFM X 7-13 RMC X 7-13 RSR X X 7-13
Sect. 7.5.4 IP Packet Parameters
CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE CODE C Q PAGE
CCS X 7-16 CSA X 7-16 EPC X X 7-16 WBL X X 7-17
CDS X 7-16 DSA X 7-16 ST1 X 7-17