Nor-Cal SDC15 Controller - Manual (Page 95)

5-45
■ Operation type
The operation type of the internal event can be set.
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
Item (Setting display/bank) Display Contents Initial value User level
Internal Event 1
Configuration 1 Operation
type
(Setup setting/Event
Configuration bank) 0: No event
1: PV high limit
2: PV low limit
3: PV high/low limit
4: Deviation high limit
5: Deviation low limit
6: Deviation high/low limit
7: Deviation high limit
(Final SP reference)
8: Deviation low limit
(Final SP reference)
9: Deviation high/low limit
(Final SP reference)
10: SP high limit
11: SP low limit
12: SP high/low limit
13: MV high limit
14: MV low limit
15: MV high/low limit
16: CT1 heater burnout/over-current
17: CT1 heater short-circuit
18: CT2 heater burnout/over-current
19: CT2 heater short-circuit
20: Loop diagnosis 1
21: Loop diagnosis 2
22: Loop diagnosis 3
23: Alarm (status)
24: READY (status)
25: MANUAL (status)
26: Invalid
27: During AT execution (status)
28: During SP ramp (status)
29: Control direct action (status)
30: During ST execution (status)
31: Invalid
32: Timer (status)
33: High and low limits of MFB value
(Invalid in this unit)
0 Simple,
Standard,
High function
0 Internal Event 2
Configuration 1 Operation
type
(Setup setting/Event
Configuration bank)
0 Internal Event 3
Configuration 1 Operation
type
(Setup setting/Event
Configuration bank)
0 Internal Event 4
Configuration 1 Operation
type
(Setup setting/Event
Configuration bank)
0 Internal Event 5
Configuration 1 Operation
type
(Setup setting/Event
Configuration bank)