Nor-Cal SDC15 Controller - Manual (Page 75)

5-25
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
■ Stopping procedures
The ST is completed automatically. If it is necessary to stop the ST halfway
during execution of the ST or not to start the ST during stopping of the ST, set the
control method of the parameter setting to “Fixed PID” (CtrL = 1). Additionally,
if the mode is changed to the READY mode or MANUAL mode, the ST is also
stopped.
● Display during execution of ST
The LED of the decimal point at the 1st digit (right end digit) of the display No. 1
is flashing while the ST is running.
When the ST is completed and PID constants are changed, this LED goes off.
rdy man ev1 ev2 ev3 ot1 ot2
para
mode
pv
sp
LED