Nor-Cal SDC15 Controller - Manual (Page 78)

■ SP setup in operation display mode
The set value for LSP in use of LSP1 to 4 can be set.
The LSP set value is different from the SP display value during SP ramp.
However, the set value is displayed while the key is being operated to change the
setting.
• When [bit 1: SP display] of the PV/SP display setup (setup C74) is set at "1"
(display is provided), the display and setting can be made.
■ LSP system group
The LSP system group can be selected.
■ LSP1 to 4
The set values can be set for four LSP groups.
• The display and setting can be made for the LSP system group selected in [LSP
system group] (setup C30).
■ LSP group number
The LSP group number can be set.
• When the LSP system group (setup C30) is set at “2” or more and [bit 2: LSP
group number display] of the PV/SP display setup (setup C74) is set at “1”
(display is provided), the display can be made.
• When the display is possible and the DI Assignment of the LSP group selection
is not performed, the setting can be made.
5-28
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
Item (Setting display/bank) Display Contents Initial value User level
SP (Operation display) SP low limit to SP high limit U 0 U Simple,
Standard,
High function
Item (Setting display/bank) Display Contents Initial value User level
LSP system group
(Setup setting/Setup bank) 1 to 4 1 Simple,
Standard,
High function
PV is
shown on
the upper
display.
Item (Setting display/bank) Display Contents Initial value User level
LSP group number
(Operation display) Numeric value at the rightmost digit of the
display.
1 to LSP system group 1 Simple,
Standard,
High function
Item (Setting display/bank) Display Contents Initial value User level
SP
(Parameter setting/SP
bank) SP low limit to SP high limit U 0 U Simple,
Standard,
High function
0 U
0 U
0 U