Nor-Cal SDC15 Controller - Manual (Page 165)

7-7
■ Continuous data write command (WS command)
This command writes data to continuous addresses.
● Send message
The figure below shows the structure of the application layer of the send message
for the data write command.
● Response message
The figure below shows the structure of the application layer of the response
message for the data write command.
● Maximum read data count per message
Up to 16 words for both RAM and EEPROM areas
Chapter 7. CPL COMMUNICATIONS FUNCTIONS
(2) (1) (3) (4)
(1) Write command
(2) Data delimiter
(3) Start write word address
(4) Write data (first word)
(5) Write data (second word)
W 0 S , 1 5 1 W , 1
(2)
, 6 5
(2) (5)
0
• Normal termination
0
• Abnormal termination or warning
X X The abnormal termination code is entered at XX.
For details of codes,
refer to
7-6, List of Termination Codes (on page 7-14).
(1)
(1)
(1) Termination code