Nor-Cal SDC15 Controller User Manual
Page 146
Chapter 6. LIST OF DISPLAYS AND SETTING DATA
Display
Item
Contents
Initial
value
User
level
Remarks
Timer remain time
display setup
0: ON/OFF delay remain time of
Internal Event is not displayed in
the operation display mode.
1: ON/OFF delay remain time of
Internal Event 1 is displayed in the
operation display mode.
2: ON/OFF delay remain time of
Internal Events 1 to 2 is displayed
in the operation display mode.
3: ON/OFF delay remain time of
Internal Events 1 to 3 is displayed
in the operation display mode.
0
1
CT display setup
0: CT current value is not displayed
in the operation display mode.
1: CT1 current value is displayed in
the operation display mode.
2: CT1 to 2 current values are
displayed in the operation display
mode.
0
1
User level
0: Simple configuration
1: Standard configuration
2: High function configuration
0
0
Communication
monitor display
0: Not used.
1: Flashing while data is sending
through RS-485 communication.
2: Flashing while data is receiving
through RS-485 communication.
3: Logical OR of all DI statuses
4: Flashing in READY mode
0
2
MV display setup
Whether or not the PV/SP value
related items are displayed in the
basic display mode is determined by
the sum of the following weights:
Bit 0: MV display
Disabled: 0, Enabled: +1
Bit 1: Heat MV/cool MV display
Disabled: 0, Enabled: +2
Bit 3: AT progress display
Disabled: 0, Enabled: +8
Other invalid settings, 0, +4
15
1
EV display setup
(Setup setting/Setup
bank)
0: Internal Event set value is not
displayed in the operation display
mode.
1: Set value of Internal Event 1 is
displayed in the operation display
mode.
2: Set values of Internal Events 1 to 2
are displayed in the operation
display mode.
3: Set values of Internal Events 1 to 3
are displayed in the operation
display mode.
0
1
Handling Precautions
• If ROM version 1 of the instrument information bank(
Id02
) is prior to
2.04, the setting options for [Number of CT1 turns], [Number of CT1
power wire loops], [Number of CT2 turns] and [Number of CT2 power
wire loops] are not displayed.
Number of CT2 power
wire loops
0: 1 time
1 to 6: Number of times
1
2
Number of CT2 turns
0: 800 turns
1 to 40: CT turns devided by 100.
8
2
Number of CT1 turns
0: 800 turns
1 to 40: CT turns devided by 100.
8
2
Number of CT1 power
wire loops
0: 1 times
1 to 6: Number of times
1
2
If the controller model has 2
current transformer inputs,
this setting is displayed.
6-12