Nor-Cal SDC15 Controller - Manual (Page 77)

5 - 7 SP
The following shows the functional block diagram of the SP:
Note
LSP is a local SP and shows that the data is retained inside this unit.
On the contrary, SP by the analog input from the outside is called RSP or remote
SP. However, the RSP function is not provided on this unit.
5-27
Chapter 5. DETAILED DESCRIPTION OF EACH FUNCTION
One LSP group exists. Two or more LSP groups exist.
LSP system group
(Setting: Setup C30)
LSP1
DI Assignment of LSP group
selection provided/not provided.
(Setting: SP SP1)
LSP group number
( Setting: LSP group number
in operation display mode)
Logical operation of DI
(Setting: General
DI Assignment)
LSP 1 to 4
(Setting: SP SP1 to SP4)
(Setting: DI Assignment
DI1.1 to DI3.1)
DI Assignment is
not provided.
DI Assignment is
provided.
SP ramp unit (Setting: Setup C32)
SP up ramp/down ramp (Setting: Parameter SPU, SPd)
DI Assignment of SP ramp enabled/disabled.
(Setting: DI Assignment DI1.1 to DI3.1)
SP low limit/high limit (Setting: Setup C07, C08)
LSP value in use
SP