Nor-Cal SDC15 Controller - Manual (Page 147)

6-13
Chapter 6. LIST OF DISPLAYS AND SETTING DATA
■ Event configuration bank
Bank selection:
Display Item Contents Initial
value User
level Remarks
Internal Event 1
Configuration 1
Operation type 0: No event
1: PV high limit
2: PV low limit
3: PV high/low limit
4: Deviation high limit
5: Deviation low limit
6: Deviation high/low limit
7: Deviation high limit
(Final SP reference)
8: Deviation low limit
(Final SP reference)
9: Deviation high/low limit
(Final SP reference)
10: SP high limit
11: SP low limit
12: SP high/low limit
13: MV high limit
14: MV low limit
15: MV high/low limit
16: CT1 heater burnout/over-current
17: CT1 heater short-circuit
18: CT2 heater burnout/over-current
19: CT2 heater short-circuit
20: Loop diagnosis 1
21: Loop diagnosis 2
22: Loop diagnosis 3
23: Alarm (status)
24: READY (status)
25: MANUAL (status)
26: Invalid
27: During AT execution (status)
28: During SP ramp (status)
29: Control direct action (status)
30: During ST execution (status)
31: Invalid
32: Timer (status)
33: High and low limits of MFB value
(Invalid in this unit)
0 0
Internal Event 1
Configuration 2 The digits are determined to 1st digit,
2nd digit, 3rd digit, and 4th digit from
the right end. 0000 0
1st digit: Direct/
Reverse 0: Direct
1: Reverse
2nd digit: Standby 0: None
1: Standby
2: Standby + Standby at SP change
3rd digit: EVENT state
at READY
0: Continue
1: Forced OFF
4th digit: Undefined 0
Handling Precautions
• If ROM version 1 of the instrument information bank ( Id02 ) is prior to
2.04, “33” cannot be set as [Internal Event configuration 1 operation
type].