Nor-Cal SDC15 Controller - Manual (Page 145)

6-11
Chapter 6. LIST OF DISPLAYS AND SETTING DATA
Display Item Contents Initial
value User
level Remarks
Key operation type 0: Standard type
1: Special type 0 2
[mode] key function 0: Invalid
1: AUTO/MANUAL selection
2: RUN/READY selection
3: AT Stop/Start
4: LSP group selection
5: Release all DO latches
6: Invalid
7: Communication DI1 selection
8: Invalid 0 0
MODE display setup Whether or not the mode bank setup
is displayed is determined by the
sum of the following weights:
Bit 0: AUTO/MANUAL display
Disabled: 0, Enabled: +1
Bit 1: RUN/READY display
Disabled: 0, Enabled: +2
Bit 3: AT stop/start display
Disabled: 0, Enabled: +8
Bit 4: Release all DO latches display
Disabled: 0, Enabled: +16
Bit 5: Communication DI1 ON/OFF
display
Disabled: 0, Enabled: +32
Other invalid settings, 0, +4, +64,
+128
255 1
PV/SP display setup Whether or not the PV/SP value
related items are displayed in the
basic display mode is determined by
the sum of the following weights:
Bit 0: PV display
Disabled: 0, Enabled: +1
Bit 1: SP display
Disabled: 0, Enabled: +2
Bit 2: LSP group number display
Disabled: 0, Enabled: +4
Other invalid settings, 0, +8
15 1
Data format
(Data length) 0: 7 bits
1: 8 bits 1 0
Station address 0 to 127
(Communication is disabled when set
at "0".) 0 0
CPL/MODBUS 0: CPL
1: MODBUS (ASCII format)
2: MODBUS (RTU format) 0 0 Displayed when the optional
model has RS-485.
Transmission speed 0: 4800bps
1: 9600bps
2: 19200bps
3: 38400bps 2 0
Data format (Parity) 0: Even parity
1: Odd parity
2: No parity 0 0
Data format (Stop bit) 0: 1 bit
1: 2 bits 0 0
Response time-out 1 to 250ms 3 2