EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 88)

Test Setup - Test Configurator, Timer, and System
78 FTB/IQS-85100G
EtherSAM - Burst
Parameters

Number of Burst Sequence is the number of times, 1 to 100 (default is
2), the burst sequence will be repeated for the CBS and EBS tests.

Refill Delay Ratio (%) is the percentage of time required to refill the
CBS/EBS token buckets. The refill delay ratio is used for post-burst
delay and the remaining percentage is applied to the pre-burst delay.
The Refill Delay Ratio is configurable from 0 to 100% (50% is the
default as well as the standard’s minimum recommended value).

Burst/IR Frame Ratio (%) is the percentage of frames transmitted at
CIR rate for the CBS test and the percentage of frames transmitted at
CIR+EIR rate for the EBS test. The Burst/IR Frame Ratio is
configurable from 10 to 90% (90% is the default as well as the
standard’s recommended percentage value).
Table
Note: Test time values are only displayed for enabled services.

Service No indicates the service number.

Service Name indicates the name of the service.

Direction, available with Dual Test Set, indicates results from local to
remote (L -> R) and remote to local (R -> L).

CBS Test Time (s) indicates the total time required to perform all burst
sequence iterations of the CBS test for this service.

EBS Test Time (s) indicates the total time required to perform all burst
sequence iterations of the EBS test for this service.

Total Burst Test Time (s) indicates the total time required to perform
all burst sequence iterations of both CBS and EBS tests for this service.