EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 343)

Packet Blazer 333
13 Suspend and Resume
Note: Suspend and Resume is not available on the IQS-600.
Suspend and Resume allow respectively the platform and its running
applications to stop (Suspend) and to be quickly re-initialized (Resume)
when the unit is turned back on.
Note: For a platform running Windows 8, the resume operation after Hibernate
or Sleep mode perform a power up and restore instead of a resume. Refer
to Power Failure Recovery on page 329.
Suspend Mode
To enter the suspend mode, hold down the platform power button a few
seconds (approximately 1.5 seconds) until the unit beeps once, and select
either the Stand By or Hibernate button. In Suspend Mode, the Packet
Blazer module is directly turned off and its configuration and injection
information are kept. The Suspend Mode remains active as long as battery
power or AC power is available. If the battery is drained the information is
lost and the Resume operation is no more possible.
The following conditions prevent the activation of the Suspend Mode:

A firmware download is in-progress

Resume operation is in-progress.
Note: The test will be stopped when entering the suspend mode meaning that the
test logger content will be lost.