EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 28)

Graphical User Interface Overview
18 FTB/IQS-85100G
Status Bar
Status Bar
The status bar displays the following information.
Icon
and/or text
Description
Test
Application
Test icon Test icon of the test. All
Interface/
Signal The interface or signal rate: 40G, OTU3, etc. All
LINK Green arrow: Ethernet Link up.
Red arrow: Ethernet Link down. All
Power Level The received optical signal status:
Green with “Power”: Power level in range
a .
Yellow: Power level out-of-range b .
Red with “LOS”: Loss of signal b .
Red with “Power”: Power level is close to damage.
Gray: The operational range value is either not available or not supplied by
the transceiver.
All
Laser ON b . The laser icon is not displayed when the laser is off a . The laser
control is not affected when turning off the laser by generating a LOS for
example. Refer to Laser Button on page 315.
All
The status of the received signal pattern:
Green: Pattern is synchronized.
Red: Loss of pattern.
Gray: Test is not running (EtherBERT test or EoOTN client) or the RX Pattern
Analysis check box is cleared. Transport
EtherBERT
A connection is established between two testing units either in Dual Test
Set (DTS) or in Loop Up mode. Ethernet
Clock synchronization signal clock. The clock icon is followed by the clock
mode: INT for Internal, EXT for External, or BKP for Backplane.
Green: Clock Synchronized.
Red: Loss of clock. All
Indicates a manual change in the OH bytes transmitted. Not displayed when
using the default OH values. Transport
Remote PC connection established with the Packet Blazer. N/A