EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 49)

Packet Blazer 39
7 Selecting and Starting a Test
A test can be created either by selecting the test from the Test Applications
tab or by loading a previously saved configuration (refer to Save/Load
Button on page 321 for more information).
Transport Test Applications
To select, configure, and start a Transport test:
1. From the test menu, tap Setup.
2. From the Test Applications tab, under Transport, tap a test icon.
3. From the Test Configurator tab configure the signal structure and its
parameters.
3a. Tap the Modify Structure button to set the basic structure of the
test such as the interface/rate, connector, etc. (refer to Modify
Structure Button on page 49).
3b. Check for the CFP optical validation check mark indicating
that the CFP matches the configured interface/rate (refer to
Physical Interface Port - Test Configurator Overview on page 45).
3c. Tap the interface block to configure the signal parameters (refer
to page 43).
3d. For an embedded signal, tap the protocol block to configure the
signal (refer to page 43).
Modify Structure
Test Block
Clock Block
Interface Block
Protocol Block