EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 82)

Test Setup - Test Configurator, Timer, and System
72 FTB/IQS-85100G
EtherBERT and Unframed BERT
EtherBERT and Unframed BERT
From the Test menu, tap Setup, Test Configurator, and tap on the
EtherBERT or Unframed BERT block.
LINK
Note: Available with OTN BERT test application with Ethernet client (EoOTN).
A green/red arrow is used to indicate the status of the link at the PCS level:

A green arrow indicates that the link is up.

A red arrow indicates alarms at the PCS level, the link is down.
The Local Fault Detected, Local Fault Received, Remote Fault,
LOA (OTU4), Hi-BER (OTU4), LOBL1027B (OTU3), Hi-BER1027B (OTU3),
and LOAML1027B (OTU3) alarms are displayed. Refer to Ethernet on
page 173, Ethernet - PCS Lanes on page 175, and Transcoding on page 203
for more information.
Restore < Test Application > Defaults
Note: Available with OTN BERT test application with Ethernet client (EoOTN).
Reverts the current test application to its default factory settings.
Pattern

Coupled RX to TX check box, when selected (default), couples both
the TX and RX signal with the same test pattern.

RX Pattern Analysis check box, when selected (default), monitors the
received traffic pattern and Round-Trip Latency. See BER on page 171
for more information.