EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 107)

Test Setup - Test Configurator, Timer, and System
Packet Blazer 97
MAC/IP/UDP
MAC/IP/UDP
Note: Only available with Framed Layer 2 (see Framing from the Modify Frame
Structure). For Traffic Gen & Mon all parameters are configurable per
stream. For EtherSAM all parameters are configured per service.
From the Test menu, tap Setup, Test Configurator, and...

For RFC 2544 and EtherBERT, tap on the protocol block.

For EtherSAM, and Traffic Gen & Mon, tap on the protocol block, and
on the MAC/IP/UDP tab.
Stream Selection (Traffic Gen & Mon)
The Traffic Gen & Mon test application supports the configuration of up to
16 different streams. Select the stream to be configured by either using the
left/right arrow or by tapping over the stream numbers area then tapping
on a specific stream number.
Service Selection (EtherSAM)
The EtherSAM test application supports the configuration of up to 10
different services. Select the service to be configured by either using the
left/right arrow or by tapping over the service numbers area then tapping
on a specific service number.
Couple with Interface
The Frame Format, Network Layer, and all IP and VLAN settings are
coupled with the interface (see Network on page 109) when the Couple
with Interface check box is selected (default). The Source MAC Address
is always coupled.