EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 248)

Test Results
238 FTB/IQS-85100G
Summary (RFC 2544)
Throughput, Back-to-Back, Frame Loss, and
Latency Subtests

Throughput, Back-to-Back, Frame Loss, and Latency
For each subtest, its status (-- (Idle), In Progress, Completed, or
Aborted - (reason)) and duration are displayed.

TX Frames
1
and RX Frames
1
display the transmitted and received
frame counts of the subtest in progress. For Dual Test Set, frame
counts are available for both directions: from local to remote (L->R)
and remote to local (R->L).

Trial #
1
displays the current trial iteration of the subtest in progress
when applicable.

Val. #
1 displays the current validation iteration of the subtest in
progress when applicable.

Step
1
displays the current step of the subtest in progress when
applicable.

Displayed Results: Select the displayed result mode: Current,
Minimum (default), Maximum, or Average.

Throughput/Back-to-Back/Frame Loss/Latency table.
Each frame size used for the test is displayed with its subtest statistics.
Statistics values are displayed based on the Displayed Results setting.
“--” indicates that the result is not available because the test has not
run yet. While testing, one of the following messages is displayed for
each frame size: Initializing, Learning, Testing, Waiting, Not
measurable, Aborted, Link is Down, or MAC not resolved.
Dir. (Direction), available with Dual Test Set, indicates results from
local to remote (L->R) and remote to local (R->L).

Unit: Select the subtest result unit:
1. Only displayed once the test is started.