beautypg.com

Ethernet test applications – EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 User Manual

Page 51

background image

Selecting and Starting a Test

Packet Blazer

41

Ethernet Test Applications

Ethernet Test Applications

To select, configure, and start an Ethernet test:
1.
From the test menu, tap Setup.

2. From the Test Applications tab, under Ethernet, tap a test icon.

3. From the Test Configurator tab configure the interface structure and

its parameters.

3a. Tap the Modify Structure button to set the basic structure of the

test such as the interface/rate, connector, etc. (refer to Modify
Structure Button
on page 49).

3b. Check for the CFP optical validation check mark

indicating

that the CFP matches the configured interface/rate (refer to
Physical Interface Port - Test Configurator Overview on page 45).

3c. Tap the interface block to configure the interface parameters

(refer to page 43). Ensure that the link is up and the power level
(when supported) is present in the status bar before proceeding
to the next step (refer to Status Bar on page 18).

Modify Structure

Protocol Block

Test Block

Clock Block

Interface Block

Physical

Interface Port