EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 157)

Test Setup - Test Configurator, Timer, and System
Packet Blazer 147
Streams - Global

Addressing indicates the source and destination IP addresses for each
stream. Tap on the Addressing button to modify the addressing (see
MAC and IP from the MAC/IP/UDP tab).
Batch button allows bulk configuration for stream addressing. Select
the check box of each configuration parameter that needs to be copied
and set its parameters. From Apply To, select all streams the copy
applies to and tap on the Copy From to proceed.
The following parameters are global for all streams.

Total TX Rate indicates the percentage of the total line utilization
which is the TX rate sum of all enabled streams.

Link Capacity indicates the total rate available for traffic generation.

Global Options:

Rate Unit choices are % (default), Mbit/s, Gbit/s, frame/s, and IFG.

QoS Metrics Tags Insertion check box when selected (default)
automatically adds a stream analysis tag containing Jitter, Latency,
Throughput, and sequence tags in all frames that will be
generated.

Copy Stream button allows to copy the stream configuration to one or
several streams.
Select the stream number the configuration will be copied from.
From To the following Streams, select all streams that will inherit the
configuration from the selected stream. An orange background
represents a selected stream. A stream that is already enabled (Enable
TX) cannot be selected for copy.
Tap Copy to confirm the stream configuration copy for all selected
streams.

Restore Default button reverts the current test application to its default
factory settings.