EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 232)

Test Results
222 FTB/IQS-85100G
Service Configuration - Burst
Service Configuration - Burst
From the Test menu, tap Results, Service Configuration, and the Burst
tab.
Service Name and Selection
Service Name indicates the name of the selected service.
Select the service to be displayed by either using the left/right arrow or by
tapping over the service numbers area then tapping on a specific service
number. An orange background indicates the selected service while a
green background indicates the services that are enabled.
Committed/Excess

Committed - Burst test is the CBS subtest.

Excess - Burst test is the EBS subtest.

Direction, available with Dual Test Set, indicates results from local to
remote (L -> R) and remote to local (R -> L).

Burst Size indicates the size in bytes of the burst used for each subtest.

SLA Verified indicates the committed SLA parameters that are used to
declare the pass/fail verdict. See Summary (EtherSAM) on page 234 for
more information on Frame Loss, Max Jitter, Round-Trip Latency,
and Max RX Rate.

Informational parameters are for information purpose only, they are
not included in the test pass/fail verdict. See Summary (EtherSAM) on
page 234 for more information on Frame Loss, Max Jitter, and
Round-Trip Latency.

Average RX Rate indicates the measured average utilization
throughput for the CBS subtest.