EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 132)

Test Setup - Test Configurator, Timer, and System
122 FTB/IQS-85100G
RFC 2544 - Subtests
Thresholds Button
Note: For Dual Test Set, thresholds are configurable for Local to Remote and
Remote to Local directions.

Throughput Threshold sets the threshold
1 value used to declare a
pass/fail verdict and it applies to all frame sizes when applicable. The
range is as follows:

Back-to-Back Threshold sets the threshold
1 value in percentage of
frames per burst to declare a pass/fail verdict. The range is from 0.0 to
100.0% (default) and it applies to all frames sizes when applicable.

Frame Loss Threshold (%) sets the threshold
2
value of frame loss.
The range is from 0.000 to 100.000 (default is 0.100) and it applies to
all frame sizes when applicable.

Latency Threshold / Round-Trip Latency Threshold sets the
threshold value as the maximum delay in ms or μs. The range is from
0.5 to 8000.0 ms (default is 125.0 ms) and it applies to all frame sizes
when applicable.

Latency Unit allows to either select ms or μs as the reference unit for
the Latency Threshold.
1. The verdict is PASS when the received/measured value is greater or equal to the threshold value.
Interface
Speed
Max. Rate
% Mbit/s Gbit/s
40G 0.000 to 100.000 a
a. Default value.
0.000 - 40000.000 a 0.000 - 40.000 a
100G 0.000 to 100.000 a 0.000 - 100000.000 a 0.000 - 100.000 a
2. The verdict is PASS when the received/measured value is lower or equal to the threshold value.