EXFO FTB/IQS-85100G Packet Blazer for FTB-500/IQS-600 - Manual (Page 122)

Test Setup - Test Configurator, Timer, and System
112 FTB/IQS-85100G
Network

Default Gateway allows the configuration of the default gateway
address to forward packets outside the subnet.

Mode
Automatic (default) allows automatic selection of the default
gateway.
Static allows entering the default gateway IP address.

Address, available with Static mode, allows to enter the IP address
of the Default Gateway. The accepted range is from
0000:0000:0000:0000:0000:0000:0000:0000 to
FE80:0000:0000:0000:FFFF:FFFF:FFFF:FFFF. The default address
is FE80:0000:0000:0000:0000:0000:0000:0000.
VLAN
VLAN Tag check box, when selected (cleared by default), enables and
allows to set up to 3 stacked VLANs.
For each VLAN tag enabled, C-VLAN / S-VLAN / E-VLAN, the following
parameters are configurable.

VLAN ID: Enter the VLAN ID. Choices are 0 through 4095; refer to VLAN
ID and Priority on page 402 for more information.

Priority: Select the VLAN user priority. Choices are 0 to 7; default is 0
(000 - Low Priority). Refer to VLAN ID and Priority on page 402 for
more information.

Type: Allows the selection of the VLAN Ethernet Type. Choices are
0x8100 (default for C-VLAN), 0x88A8 (default for S-VLAN), 0x9100
(default for E-VLAN), 0x9200, and 0x9300.

Drop Eligible, when set to Yes (DEI = 1), the transmitted frames will
be dropped first on receipt when congestion occurs under test. Drop
Eligible is not available when VLAN type is 8100. This setting is set to
No by default.