Haltech E8 - Manual (Page 8)

Haltech E11/E8 Instruction Manual
Tools and Materials that you will need
Installation of this system can be easily carried out by professional mechanic(s) and most experienced
home mechanics if the following tools and components are available:
Voltmeter or Test Light
A selection of screwdrivers and spanners
Soldering Iron and solder
(It is recommended that all connections be soldered except where crimped terminations are used.
Soldering crimped terminations can cause the wire at the crimp to become weak. Most crimped
terminations have sufficient strength alone as long as the appropriate crimping tool has been used)
Wire Cutters and Pliers
Crimping Tool and assorted terminals
Drill with assorted drill bits
3/8" NPT Tap
14mm x 1.5 Tap
Electrical Tape or Heat Shrink tubing
Teflon pipe sealing tape
Nylon cable ties
Jeweller’s file (may be needed for mounting Throttle Position Sensor)
Mounting hardware for ECU and relays (mounts/bolts/screws)
Personal Computer (preferably a laptop or portable computer) running Windows 95/98, Windows 2000 or
Windows XP with an RS232 serial port. See section for the requirements of your PC.
A good quality Timing Light
Page: 8 Copyright © Haltech 2008