Haltech E8 - Manual (Page 164)

Haltech E11/E8 Instruction Manual
Disk Drive - CD-ROM drive
Serial Port - Standard RS232C port - 9 pin D connector
Adjustable Features
Base Fuel Map
32 Fuel ranges, default 500 rpm to 16,000rpm (with programmable ranges)
32 Load points per range, up to 32ms with 6.4us resolution
Ignition Map
32 Ignition ranges, default 500 rpm to 16,000rpm (with programmable ranges)
32 Load points per range, up to 60° advance, with 0.1° resolution
Correction Maps
Fuel
Cold Start Prime - 32 points
Coolant Temperature Enrichment - 32 points
Air Temperature Adjustment - 32 points
Battery Voltage Correction - 32 points
Closed Throttle (selectable) - 32 points
Full Throttle (selectable) - 32 points
Ignition
Crank Advance - 32 points
Coolant Temperature Advance/Retard - 32 points
Air Temperature Advance/Retard - 32 points
Programmable Rev-Limit - selectable as either fuel or ignition Soft/Hard Cut
Fuel Cut on Deceleration
Accelerator Pump - for transient throttle situations
Idle Speed Control
Target Idle Speed
Cold Idle-up RPM
Post-start RPM setting
Closed Loop O2 Control - With both cruise and idle settings, wideband and narrowband
Programmable Output Options
Data logging - Engine data information logged at a nominal rate of 10 times per second Stored to memory
or disk Limited only by available memory.
On Board Data logging - Engine data information logged at 1,10 or 200 samples per second. 448kB of
Flash memory storage.
Map Storage and Retrieval - Maps may be stored to disk and re-used.
Real Time Programming - Instant, hesitation free adjustment while engine is running.
Rugged Aluminium Casing - Black anodised with integral cooling fins and mounting brackets.
Optional Boost Control Solenoid .
Optional Dual Hall Effect Sensor Kit .
Optional Four Wire Heated Oxygen Sensor .
Optional Idle Air Control Motor Housing .
Page: 164 Copyright © Haltech 2008