Haltech E8 - Manual (Page 6)

Haltech E11/E8 Instruction Manual
Introduction
Congratulations on purchasing a Haltech Engine Management System. This fully programmable product
opens the door to virtually limitless performance modification and tuning of your vehicle. Programmable
systems allow you to extract all the performance from your engine by delivering precisely the required
amount of fuel and ignition timing that your engine needs for optimum output under all operating
conditions.
This Installation and Wiring Guide will guide you through installing your Haltech ECU onto your vehicle.
This section accompanies the Setup Guide and Tuning Guide that you or your tuner will need to refer to
before completing your installation and configuration.
Before You Begin
IT IS BEST TO READ THIS ENTIRE MANUAL BEFORE STARTING .
At the very least, you should read Section One of the manual before you begin the wiring part of the
installation. The greater your knowledge of the operation of the Haltech system, the easier you will find it
to understand what you are doing, and why. Throughout the manual are Warnings and Notes that will
help your installation run smoothly and indicate the dangers that can exist for you the installer and the
Haltech ECU.
Read any additional material (if supplied) accompanying this manual that updates the document since it
was written.
You may need special parts or additional tools or test equipment in order to complete installation. Make
sure you have these items on hand before you begin to avoid frustration.
Don't do the minimum work possible. Carelessness in the early stages of installation can cause greater
problems later on. Carelessness will cost you money and frustration in finding and fixing unnecessary
problems. You have the opportunity to make sure your Haltech system's operation is extremely
dependable and easy to use by Doing it right the first time !. Another reason to exercise care during this
installation is make sure there is no Fuel leaks and no wiring un-insulated which can cause a spark or a
short and cause a fire or an explosion. Also make sure you follow the proper workshop precautions like
when working underneath a jacked-up car, make sure you use safety stands.
Page: 6 Copyright © Haltech 2008
Installation and Wiring Guide