Haltech E8 - Manual (Page 58)

Haltech E11/E8 Instruction Manual
the relay on not powering the engine or its components).
Figure 55 - Engine Control Relay Wiring
Extra Injector
Select extra injector output for additional staged injection. You can select as many extra injectors as the
number of free timed channels allows. The additional injector will pulse at the same time as injector 1. The
injection mode is defined by the staged injection setup found in the fuel setup page. See section fuel
setup page.
Generic Switching Outputs
The generic switch outputs can be used to drive a relay, device or warning light for any application based
on a generic ECU input. All generic switch outputs are simply on/off switches with the exception of the
generic load PWM map, this output is a fully mappable 32x32 load RPM map.
The generic switch options are as follows:
Generic Air Temperature Switch – Allows the output to be switched on and off again at the users
desired air temperatures as measured by the air temperature sensor.
Figure 56 - Genericl Air Temp Switch
Generic Coolant Temperature Switch - Allows the output to be switched on and off again at the users
desired coolant temperatures as measured by the coolant temperature sensor.
Page: 58 Copyright © Haltech 2008
12V 12V 12V
OR
ECU Output ECU Output To Engine
To Engine