Futaba 18MZ 2.4GHz - Manual (Page 92)

92
Model 1
Trim
Unit
LST
+0%
( +0%)
RST
+3%
( +3%)
LD
-11%
( -11%)
RD
-2%
( -2%)
LS
-2%
T6
+0
T5
+0
T4
+0
T1
+0
T3
+0
T2
+0
+2
( -2%)
RS
+0%
( +0%)
85%
Dial Monitor
Step
10
4 4 4 4
4
CD
Condition 1
●Return to Linkage Menu
● Touch the [Dial Monitor] button in the Linkage
Menu to call the setup screen shown below.
● Trim changes from the step to % display.
Dial Monitor LDisplays the position of the dials, slider levers, and digital trim.
Digital trim position display (T1-T6, CD)
The Dial Monitor displays the current position
and step amount of each Digital Trim. The trim step
can be set directly on the dial monitor.
VR and slide lever position display (LST, LS, LD,
RD, RS, RST)
Displays the current position (black ) and last
operating position (green ) of the VRs and slider
levers.
Knob and Lever Position display
(LD, RD, LS, LST, RS, RST)
The Dial Monitor displays the current position
and last operating position of each knob and lever.
Although neither knob nor lever can hold the last
operation position as they are “analog” type, the
position data during the last operation is memorized
in the model memory. By moving the knob and
lever to the position displayed on the monitor, the
last operation position is recalled.
Recalling Dial Position
(LST, LS, LD, RD, RS, RST)
The dial position data at the last operation is
displayed for each knob and lever in this monitor.
(Green arrow)
1. Move the black arrow (current position)
to the green arrow position by operating
the desired knob or lever to recall the last
operating position.
Digital trim step amount (T1-T6, CD)
The trim step of the T1-T6 and CD can be set
directly on the dial monitor menu.
●Digital trim step amount