Futaba 18MZ 2.4GHz - Manual (Page 8)

8
Lithium polymer(Li-po) Battery Safety and Handling instructions
IMPORTANT!
Use only the Futaba special charger included with this set or other chargers approved by Futaba to
charge the Li-po batteries in the T18MZ transmitter included with this set.
It is important to understand the operating characteristics of Li-po batteries.Always read the specifications
printed on the label of your Li-po battery and charger prior to use. Failure to follow the proceeding precautions
can quickly result in severe, permanent damage to the batteries and its surroundings and possibly result in a
FIRE!
IMPORTANT PRECAUTIONS
Do not attempt to disassemble Li-po packs or cells.
Do not allow Li-po cells to come in contact with moisture or water at any time.
Always provide adequate ventilation around Li-po batteries during charge, discharge, while in use, and
during storage.
Do not leave a Li-po battery unattended at any time while being charged or discharged.
Do not attempt to charge Li-po batteries with a charger that is NOT designed for Li-po batteries, as
permanent damage to the battery and charger could result.
Always charge Li-po batteries in a fireproof location. Do not charge or discharge Li-po batteries on carpet,
a cluttered workbench, near paper, plastic, vinyl, leather or wood, or inside an R/C model or full-sized
automobile! Monitor the charge area with a smoke or fire alarm.
Do not charge Li-po batteries at currents greater than the “1C” rating of the battery (“C” equals the rated
capacity of the battery).
Do not allow Li-po cells to overheat at any time! Cells which reach greater than 140 degrees Fahrenheit
(60°C) should be placed in a fireproof location.
Li-po cells will not charge fully when too cold or show full charge.
It is normal for the batteries to become warm during charging, but if the charger or battery becomes
excessively hot disconnect the battery from the charger immediately!! Always inspect a battery which has
previously overheated for potential damage, and do not re-use if you suspect it has been damaged in any
way.
Do not use a Li-po battery if you suspect physical damage has occurred to the pack. Carefully inspect the
battery for even the smallest of dents, cracks, splits, punctures or damage to the wiring and connectors. DO
NOT allow the battery’s internal electrolyte to get into eyes or on skin—wash affected areas immediately
if they come in contact with the electrolyte. If in doubt, place the battery in a fire-proof location for at least
30 minutes.
Do not store batteries near an open flame or heater.
Do not discharge Li-po batteries at currents which exceed the discharge current rating of the battery.
Always store Li-po cells/packs in a secure location away from children.
Never remove the SD card or turn off power while
entering data.
Never store the SD card where it may be subject
to strong static electricity or magnetic fields.
Do not expose the SD card to direct sunlight,
excessive humidity or corrosive environments.
Do not expose the SD card to dirt, moisture, water
or fluids of any kind.
Be certain to insert the SD card in the correct
direction.
Secure Digital (SD) Memory Card Handling Instructions
(SD card is not included with this set)