Futaba 18MZ 2.4GHz - Manual (Page 75)

75
●Return to Linkage Menu
● Touch the [Sound] button in the Linkage Menu
to call the setup screen shown below.
● Touch the file button
Copy/Delete/Entry/
Rename is made.
I t i s t h e s a m e
procedure as the
p i c t u r e o f t h e
preceding clause.
Sound Sound recording and playback.
(Saved sound file)
[Important]
Before reading data from a PC, insert the
SD card/USB memory into the transmitter and
turn on the power. The following folders are
automatically written. When reading a file from
the PC, copy it to a holder by file type.
●BMP: Picture file ●WAV: Audio file
●WMA: Music file ●MODEL: Model data
Sounds recorded with the microphone built into
the transmitter or any audio files (.wav) can be set
to the power switch or any preset switch that you
choose.
*Only a .wav file saved in the same storage place (T18MZ,
SD card, a USB memory) as the current model can be
chosen.
*The maximum recording time from the microphone is 3
seconds. Twenty-four audio files can be saved.
*The only audio file type which can be recorded is .wav.
Only the sounds recorded with the built-in microphone or an
audio file saved from your PC to an SD card can be played
back.
Setup screens No. 3 to 24 can be individually
assigned to audio file switches, etc. The playback
files can be switched each time the same switch is
operated. This can be used when playing back the
name of maneuvers, etc.
[Sound starting]
No. 1: When transmitter power switch turned on
No. 2: When transmitter power switch turned off
No. 3~24: Switch can be set.
Voice Recording
1. Touch any REC button to call up the SOUND
RECORDER screen.
2. Touch the REC button to start recording.
(Recording time: 3 seconds)
3. Record your voice as you are facing the
transmitter’s microphone.
*Speak loudly and clearly.
4. To finish, press “CLOSE”. Also sound files
created by your PC may be played back by
assigned switches. (File types; .wav file only)
*A voice file is saved automatically to the location of the
model you are currently using. Whether in the transmitter,
SD card,or USB memory. A file name is displayed on the
file button corresponding to a recording button.