Futaba 18MZ 2.4GHz - Manual (Page 101)

101
Condition Hold Condition hold function (Helicopter only)
This function may be used to limit the maximum
speed of the engine so that you may adjust flight
conditions when the engine is running. An alarm
indicates that the function is operating. It will
prevent the engine from racing dangerously when
adjusting the Idle-Up settings.
While this function is active, the throttle servo
position is fixed at the point that you have indicated
when the function is activated. You must deactivate
this function when you are through making
adjustments.
The system will not allow you to activate/
deactivate this function in either of the following
states:
• When any of the flight condition switches
are on.
• When the throttle stick is higher than the
1/3 point.
To activate/deactivate Condition hold:
(Home screen)
1. Set the throttle stick lower than the 1/3 point.
2.Push the direct key S4 (Cond. Hold) to
activate the condition hold function.
*When this function is active, "Condition Hold is active"
appears on the screen.
(LINKAGE menu/MODEL menu)
1. Set the throttle stick lower than the 1/3 point.
2.Push the INH (or the direct key S4) button to
activate the condition hold function.
*Operation is displayed at the bottom of the menu.
Function ON: "ON" is displayed.
Function OFF: "INH" is displayed.