KEYENCE BL-700 Series - Manual (Page 72)

Chapter 4 Installing the Setup Software
58
4
2. Enter the “Trigger ON/OFF command” from the keyboard. The command name
can be changed as desired (within 8 characters).
Normally, the initial setting (LON, LOFF) should be used as provided.
3. Enable either “Start the test mode with trigger input ON” or “Start the test mode
at power-on”.
When “Start the test mode with trigger input ON” is enabled, the trigger input
cannot be used during normal operation.
If both functions are selected, “Start the test mode with trigger input ON” has
priority.
• Scanning method
➮ P.32 to 33
• Trigger ON/OFF command
➮ P.91
• Starting the test mode
➮ P.40 to 43
Comm Settings-1 (Communication parameters 1)
Set the communication parameters.
When “Multi-drop (RS-485)” is enabled, the ID number setup menu also appears.
Set the ID number to a value from 1 to 31. “RTS/CTS protocol” is then disabled.
• RTS/CTS protocol
➮ P.88
• Multi-drop
➮ See the Multi-drop Controller N-400 User’s Manual.
Tips
Tips