6 dotfax plugin, 7 administration, 1 loader – FaxBack NET SatisFAXtion 8.6 - Manual User Manual
Page 227

4 – Appendices
NET SatisFAXtion 8.6 Manual
227
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400
,
12000
,
9600
,
7200
,
4800
and
2400
. Default:
14400,12000,9600,7200,4800,2400
.
allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400
,
12000
,
9600
,
7200
,
4800
and
2400
. Default:
14400,12000,9600,7200,4800,2400
.
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or
“answering” states for a carrier from the remote device before hanging up.
Default:
45
.
csid [string(20)]: The CSI for receive and the TSI for send.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state
before hanging up. Default:
45
.
fax_device_name [string]: Optional device name that will override the key
name that is used for the fax device name. Typically this is never used. Format:
Up to 32 characters.
phone_number [string]: Specifies a value that the IP fax driver sets in the
From:
header of SIP messages that it creates, identifying the IP fax port. A VoIP
router can, if so configured, pass along this value as the caller ID (ANI) for the
outbound fax call.
4.2.1.6
DotFax Plugin
rings_before_answer [dword 0–255]: Number of rings before modem
accepts call. Default: 1
send_por t_count [dword 0–65535]: Number of send-only ports to configure.
send_receive_por t_count [dword 0–65535]: Number of send/receive ports
to configure.
receive_por t_count [dword 0–65535]: Number of receive-only ports to
configure.
csid [string(20)]: The CSI for receive and the TSI for send.
4.2.1.7
Administration
Configuration key for the Administration program.
BillingCodeManager [string]: Path to BillingCodeManager.exe.
Repor ting [string]: Path to Reports.exe.
4.2.1.7.1
Loader
(Default) [string]: Resource.dll offset.