FaxBack NET SatisFAXtion 8.6 - Manual User Manual

Page 219

4 – Appendices

NET SatisFAXtion 8.6 Manual

219

init_string [string]: This is the basic modem initialization string. It should reset
the modem and init the required flow control. Format: Up to 80 characters.
Default:

&F&C1&D2V1E0S0=0S7=90^^

All modem commands start with AT, so this string does not need AT. The
symbols in the string mean the following:

2-second pause

Carriage return. There is a wait of

init_string_timeout_msecs

after carriage return to wait an

to be

returned.

Specifies a single

^^\

this is interpreted as

\^^

init_string_timeout_msecs [dword 0–65535]: How long to wait for
response after

in the

init_string

if there are no 2-second pauses before or

after the

. Default:

5000

io_buf fer_size [dword 0–65535]: This is the size of the image buffer. The
necessary buffer size depends on host CPU speed and load as well as connect
speed. This buffer directly adds to driver page locked memory use so should be
as small as possible. However, too small a buffer will cause faxes to fail. Default:

20480

show_console_scroll_back_buffer_size [dword 0–4294967295]: When
the debug output is

CONSOLE

, this is how big of a buffer to be used for scrollback.

Default:

282144

show_ring0_buffer_size [dword 0–4294967295 ]: How big of buffer for the
page locked debug buffer that ring0 code writes to and ring3 code extracts from
(on a thread) to the debugging output. This should be larger for when using
serial capture mode since so much more data is written for debug. It should
probably be only about 1K for when using T.30 debug since the frequency and
amount of T.30 debug is small enough that the ring3 code can easily keep up
writing to the show output. Default:

65536

debug_show_file_path [string(256)]: Partial path or complete path and file
name of where to create debug file. If the debug_show_output is set for
CONSOLE and the debug_show_file_path is specified in the registry, then you
can get both CONSOLE and FILE debug output simultaneously. This is a device
specific setting, but you can set the default for all devices by specifying this
under the global icanfax section.

csid [string(20)]: The CSI for receive and the TSI for send.

allowed_receive_image_types [string]: These settings control the image
types that the device can send and receive via the T.30 protocol over the
telephone network. To receive or send some image types, the corresponding

allowed_receive

send_transfer_type

setting must include ECM. Format:

Comma separated list of the following. Default:

1D,2D,T6,JBIG

2D
T6

JPEG
JBIG

COLOR
200H_400V

300H_300V
400H_400V