FaxBack NET SatisFAXtion 8.6 - Manual - Manual (Page 221)

4 – Appendices NET SatisFAXtion 8.6 Manual 221
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state
before hanging up. Default:
45 .
tapi_modem_name [string(128)]: When specified, the driver will utilize TAPI
so as to not monopolize the usage of the serial port. This is the name of the
modem defined in the control panel modem applet.
tapi_modem_name_saved [string(128)]: Copy of tapi_modem_name .
fax_device_name [string(32)]: Optional device name that will override the key
name that is used for the fax device name. Typically this is never used.
csid [string(20)]: The CSI for receive and the TSI for send.
4.2.1.4 Convert
header_font [string]: Font used for fax header text conversion. Default:
{ProgramPath}\Fonts\header.fnt .
compressed_font [string]: Font used for compressed text document
conversion. Default:
{ProgramPath}\Fonts\compress.fnt .
normal_font [string]: Font used for plain text document conversion. Default:
{ProgramPath}\Fonts\normal.fnt .
4.2.1.5 IP_FAX Global
allowed_receive_baud_rates [string]: This setting constrains a modem to
use only certain baud rates. Use this to block a modem from using a rate or
rates that it supports, but are unreliable in your environment or are undesirable
for some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
allowed_send_baud_rates [string]: This setting constrains a modem to use
only certain baud rates. Use this to block a modem from using a rate or rates
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400 , 12000 , 9600 , 7200 , 4800 and 2400 . Default:
14400,12000,9600,7200,4800,2400 .
allowed_receive_image_types [string]: These settings control the image
types that the device can send and receive via the T.30 protocol over the
telephone network. To receive or send some image types, the corresponding
allowed_receive / send_transfer_type setting must include ECM. Format:
Comma separated list of the following. Default: 1D,2D,T6,JBIG .
1D
2D
T6
JPEG
JBIG
COLOR
200H_400V
300H_300V