FaxBack NET SatisFAXtion 8.6 - Manual User Manual
Page 223
4 – Appendices
NET SatisFAXtion 8.6 Manual
223
audio_qos_max_sdu_size [dword 0–65535]: MaxSduSize of sending RTP
RSVP FlowSpec. Default:
340
.
audio_qos_minimum_policed_size [dword 0–65535]:
MinimumPolicedSize of sending RTP RSVP FlowSpec. Default:
340
.
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or
“answering” states for a carrier from the remote device before hanging up.
Default:
45
.
csid [string(20)]: The CSI for receive and the TSI for send.
debug_show_file_path [string(256)]: Partial path or complete path and file
name of where to create debug file. If the debug_show_output is set for
CONSOLE and the debug_show_file_path is specified in the registry, then you
can get both CONSOLE and FILE debug output simultaneously. This is a device
specific setting, but you can set the default for all devices by specifying this
under the global ICANFax section.
debug_show_mode [string]: Specifies the types of debug information to
output. Format: Comma separated list of one or more of the following.
Default:
T30,SIP,API,T38,T38_DATA,T38_IMAGE
.
T30
Contents of all sent or received T.30 messages (fax protocol
signals like CSI, DIS, TSI, DCS, etc.).
SIP
The contents of each sent or received SIP packet.
API
Internal API state.
T38
The basic contents of each sent or received T.38 packet.
Required for all the remaining T38 debug types except T38_PKT.
T38_ERROR_RECOVERY
List the contents of the secondary (redundant)
payload in each T.38 packet. This option generates a lot of data.
T38_DATA
Dump the decoded bytes of any low-speed T.38 (control)
packets both primary and secondary (redundant) payloads. This
option generates a lot of data.
T38_IMAGE
A brief summary of any high-speed T.38 (image) packets
both primary and secondary payloads.
T38_IMAGE_DATA
Dump the decoded bytes of any high-speed T.38
(image) packets both primary and secondary (redundant) payloads.
This option generates a lot of data.
T38_PKT
Dump the raw bytes of each T.38 packet received. This
option generates an extremely large amount of data and is only used
to diagnose possible T.38/ASN.1 parsing problems.
RTP
Log each sent or received audio packet.
CALL_PROGRESS
Log periodic audio state during the RTP portion of the
call (pre-T.38 reinvite).
debug_show_tcp_url [string]: Connect to this host:port to log debug
information.
debug_show_output [string]: Debug output that displays various run time
behavior of ICANFax. When specifying the
FAX_DEVICE
, the ICANFax debug
output will be mixed in with the fax drivers debug output. This is a device
specific setting, but you can set the default for all devices by specifying this
under the global section. Format: One of the following values. Default:
NONE
.
NONE
CONSOLE
FILE
FAX_DEVICE